Edgers
Our board edger shift assemblies are made to be easily configured to custom lengths for many machine setups, and include everything for ease of installation. Designed to function in sawmill environments day in and day in a out for decades with little to no need for service. They use the same delrin ® bearings that are common to all of our sliding products, requiring little to no maintenance. The units work very well even in the harshest of environments and can handle the stresses produced by vertical edgers.
Excellent for vertical and horizontal board edgers, and any other application that requires linear positioning of a laser for alignment.
SA-001 Unison Shift Assembly
The SA-001 unison shift assembly is what is often referred to as “equidistant”. When one saw moves, the opposite saw moves with it, either apart, or together.
Mounting Bolts Spacing:
End plates, 2 ea 5/16″ thru-bolts, 2.750″ spacing
End plate hole distance, same as ordered shaft length
Lengths Available:
24″ up to 72″
Standard length 48″ unless otherwise requested
Lengths over 48″ will incur additional per foot charges
Included Installation Parts:
4 pcs Swivel block (routing) pullies
4- 5/16 x 1.5″ mounting bolts with washers and nuts
2 pcs cable clamps 1/8″ ac
50′ ac cable
* You can also add an SA-009 stationary bracket to allow for a stationary saw. Unison Shift Assembly
SA-002 Independent Shift Assembly
The SA-002 independent shift assembly is just that, configured for independent saws. Both saws can be moved seperately.
Mounting Bolts Spacing:
End plates, 2 ea 5/16″ thru-bolts, 2.750″ spacing
End plate hole distance, same as ordered shaft length
Lengths Available:
24″ up to 72″
Standard length 48″ unless otherwise requested
Lengths over 48″ will incur additional per foot charges
Included Installation Parts:
6 pcs Swivel block (routing) pullies
4- 5/16 x 1.5″ mounting bolts with washers and nuts
4 pcs cable clamps 1/8″ ac
2 pcs 50′ ac cable
* You can also add an SA-009 stationary bracket to allow for a stationary saw. Independent Shift Assembly
Frequently Asked Questions
Due to overall complexity and cable routing density issues, we don’t have a 3 saw moving assembly per se. In such a situation, we suggest ordering one standard two saw assembly (SA-001 or SA-002), then adding another assembly configured for one moving unit. Please call if you have questions.
Replacement bearing sets can be purchased. Give us a call.
No problem, we sell these separately as we know not all installations are the same and routing may require more than the standard number.