Faqs

Is the indicator light a Green LED? A: You may have a bad power supply. Try running power from an alternate outlet first. If you have another unit, swap the PSU and see if that works, if it does, [...]

Give us a call and we can figure out what parts you need to get you back up and running!

Have you cleaned the lens? You can use windex or alcohol to clean the lens gently. Visually confirm that the cleaning was successful and all dust, pitch, or other has been removed. I’ve cleaned [...]

Is the unit on a Rip Saw? IF YES: Static from the dust collection system may be causing the laser to fault and require a reset. Route the power supply cable well away from the dust pipe and [...]

The indicator light shows if the laser is receiving power input. If you have no laser line output or it’s weak and the light is on you will need to send the unit in for servicing. Please [...]

Did you power cycle the laser and still nothing? Unit must be sent in for repair.

See our warranty page

Box well, and ship to us here: Lumberline Laser, Inc. 12119 NE 99th St. Suite 2040 Vancouver, WA 98682 Include address, contact name, phone number, and email. We will check the unit out and [...]

Contact us by toll-free by phone at (855)686-3077 or at [email protected] to place your order.

With three rails, if you stack and stagger the trolleys from top to bottom in a tier formation, you can achieve a minimum of 1.00” of spacing between lines. With two rails, that goes up to 1.50”. [...]